Winches Plus - Accessories

Winches Plus
Accessories

Hydraulic Filter

This magnetic filter provides dual filtration that is designed to be completely
effective in removing ferrous metal particles from power steering lubricating systems.
When the fluid passes within the effective range of the magnet, the filter attracts the ferrous
particles down to a sub-micron level. The secondary paper filtration media removes the
non-ferrous material. The Filter provides full line flow capabilities for power steering systems,
and incorporates a pressure by-pass relief valve.

Note: This product comes complete with 2 appropriate hose clamps.

#FILTER

$30

Mile Marker Winch Accessory Kit

The tow strap is 15' long and rated at 30,000 lbs.

#19-00001

$185

Hydraulic Pressure Gauge

0 - 2000 psi
This is a tool for testing the line pressure of your hydraulic system. It has JIC-6 fittings, one male and one female. It comes ready to install in any line as a bolt on device. This is the same tool we use in our workshop to test systems.

#GAUGE

$40

Hydraulic Cooler

Optional for heavy duty winch use.
Kit includes mounting hardware, hose, and hoseclamps.

#COOLER

$40

MileMarker Synthetic Rope

MileMarker Synthetic Rope
3/8 x 100 feet
Minimum breaking force 16,200 lbs.

#19-52038-100C

$290

Power Steering Pump

New high output Saginaw power steering pump. 3/4" shaft.
We sell this pump in two models, 3.5 gpm and 5 gpm. Both run at 1500 psi.
Just tell us which one you need or we'll help you identify the right one for your application.

#PUMP

$175

Heavy Duty Snatch Block

24,000 lb. rating uses grease fitting to provide less friction on pully rotation.

#60-50085

$98

2" Receiver Winch Mount rated at 12,000#

Used to mate a winch to a standard 2 inch square front or rear hitch receiver.
This receiver has been tested and rated at 12,000 lbs. It is also flat on the bottom.

$195

Front Mount Quick Disconnect Kit

This kit will enable you to put the MileMarker winch on a quick disconnect system for the front mount, if you desire to install the MM winch on a receiver type hookup.

#70-54000

$86

Rear Mount Quick Disconnect Kit

This kit will enable you to put the MileMarker winch on a quick disconnect system for the rear mount, if you desire to install the MM winch on a receiver type hookup.
(includes two 20' hoses)

#70-53000

$208

Neoprene Winch Cover